Radio/Stereo: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel from the instrument panel.
3. Remove the four screws that secure the radio receiver to the instrument panel.
4. Pull the radio receiver out from the instrument panel far enough to access the instrument panel wire harness connectors and the antenna coaxial cable connector.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

Fig.6 Antenna To Radio:

5. Disconnect the antenna cable by pulling the locking antenna connector away from the radio (Fig.6).
6. Disconnect the instrument panel wire harness connectors.
7. Remove the radio receiver from the instrument panel.

INSTALLATION
1. Position the radio receiver to the instrument panel.
2. Reconnect the instrument panel wire harness connectors and the antenna coaxial cable connector to the receptacles on the rear of the radio receiver.
3. Position the radio receiver into the mounting hole in the instrument panel.
4. Install and tighten the four screws that secure the radio receiver to the instrument panel. Tighten the screws to 2.25 Nm (20 in. lbs.).
5. Install the cluster bezel onto the instrument panel.
6. Reconnect the battery negative cable.