Rear Floor Heat Duct Replacement

REMOVAL
Split Bench Seat

Fig.2 Rear Seat Floor Duct Control - Split Bench Seat:

1. Remove the three retainers that secure the HVAC rear bezel to the brackets near the back of the front seat center section.
2. Pull the bezel away from the back of the front seat far enough to access and disengage the control cable retainer and cable end from the control.

Bucket Seat
The rear floor duct control and linkage are only serviced as a unit with the console duct assembly.

Fig.3 Rear Seat Floor Duct Control - Bucket Seat:

1. Remove the four screws that secure the console bin and remove the bin from the floor console.
2. Reach through the top of the console to disengage the control rod end from the floor duct damper door pivot.
3. Remove the floor console from the vehicle and disassemble as required to remove the console duct and control assembly from the console as a unit.

Rear Seat Floor Duct
The rear seat floor duct damper door is only serviceable as part of the rear seat floor duct on bench seat models, or the center seat floor duct on bucket seat models.
1. Remove the carpeting from the floor panel transmission tunnel.

Fig.1 Rear HVAC Housing:

Fig.4 Rear Seat Floor Ducts Remove/Install - Bucket Seat:

Fig.5 Rear Seat Floor Ducts Remove/Install - Split Bench Seat:

2. Remove the retainers that secure the ducts to the floor panel transmission tunnel
3. Remove the duct(s) from the floor panel as required.

INSTALLATION
Split Bench Seat
1. Install the bezel to the back of the front seat far enough to allow access to engage the control cable retainer and cable end to the controller.
2. Install the three retainers that secure the HVAC rear bezel to the brackets near the back of the front seat center section.

Bucket Seat
1. Assemble the floor console as required to install duct and control assembly.
2. Install floor console into vehicle.
3. Reach through the top of the console to engage the control rod end to the floor duct damper door pivot.
4. Install the three retainers that secure the HVAC rear bezel to the brackets near the back of the front seat center section.

Rear Seat Floor Duct
1. Install the duct(s) to the floor panel as required.
2. Install the retainers that secure the ducts to the floor panel transmission tunnel.
3. Install the carpeting to the floor panel transmission tunnel.