Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION SENSOR

Fig.17 Distributor And CMP Location - 5.9L:

The Camshaft Position Sensor (CMP) is located inside the distributor. Distributor removal is not necessary to remove camshaft position sensor.

REMOVAL
1. Disconnect negative cable from battery.
2. Remove air cleaner tubing at throttle body, and at air filter housing.
3. Remove distributor cap from distributor (two screws).
4. Disconnect camshaft position sensor wiring harness from main engine wiring harness.
5. Remove distributor rotor from distributor shaft.
6. Lift camshaft position sensor assembly from distributor housing.

INSTALLATION
1. Install camshaft position sensor to distributor. Align sensor into notch on distributor housing.
2. Connect engine wiring harness to sensor pigtail harness.
3. Install rotor.
4. Install distributor cap. Tighten 2 mounting screws.
5. Install air filter tubing.
6. Connect battery cable.