Blower Motor Switch: Service and Repair

REAR BLOWER MOTOR SWITCH

REMOVAL
The rear blower motor switch is used only on models with the optional rear heater-A/C unit.
1. Disconnect and isolate the battery negative cable.
2. Remove the accessory switch plate from the instrument panel.

Fig. 20 Rear Blower Motor Switch Remove/Install:

3. Rotate the illumination lamp socket counterclockwise to disengage it from the back of the switch housing.
4. Pull the knob off of the blower motor switch stem from the front of the accessory switch plate.
5. With a small thin-bladed screwdriver, gently pry the sides of the accessory switch plate to release the two snap clips on each side of the rear blower motor switch housing.
6. Remove the rear blower motor switch from the back of the accessory switch plate.

INSTALLATION
The rear blower motor switch is used only on models with the optional rear heater-A/C unit.

Fig. 21 Rear Blower Motor Switch Remove/Install:

1. Position the rear blower motor switch on the back of the accessory switch plate.
2. Firmly and evenly press the rear blower motor switch into the back of the accessory switch plate until it snaps into place. Be certain that all of the switch snap clip retainers are fully engaged.
3. Reinstall the knob onto the rear blower motor switch stem from the front of the accessory switch plate. Be certain to index the flat on the switch stem with the flat in the hub of the knob.
4. Reinstall the illumination lamp socket to the back of the rear blower motor switch housing.
5. Reinstall the accessory switch plate in the instrument panel.
6. Connect the battery negative cable.