Gear Shift Lever

REMOVAL
1. Remove the knee blocker.
2. Lower the column enough to allow clearance for the gear shift lever removal.
3. Remove the upper and lower column shroud.
4. Disconnect the overdrive switch harness (if equipped).
5. Disconnect the shift cable and unsnap the cable adjust clip from the pin.





6. Remove the gear shift lever mounting screws and remove the lever.

INSTALLATION





1. Install the lever using care to install the spring in the alignment hole and install the mounting screws and tighten to 12 Nm (105 in. lbs.).
2. Connect the overdrive switch harness (if equipped).

NOTE: Route and tie off harness to original location.

3. Connect the shift cable to the lever.
4. Ensure the gear shift lever and transmission are in the PARK position and snap the cable adjust clip in place.
5. Install the upper and lower column shroud.
6. Install the column back into place and tighten.
7. Install the knee blocker.