Removal

REMOVAL
1. Hoist and support vehicle on safety stands.
2. Mark propeller shaft and axle yoke for assembly reference. Then disconnect and remove shaft.
3. Disconnect parking brake cable at equalizer and disconnect exhaust components as necessary.
4. Support transmission on a suitable lifting device.
5. Remove skid plate and rear transmission mount.
6. Remove extension housing.
7. Loosen but do not remove bolts that hold governor body to park gear.
8. Rotate transmission output shaft until governor weight assembly is accessible.





9. Remove E-clip at end of governor valve shaft (Fig. 108).
10. Remove governor valve and shaft from governor body (Fig. 108).





11. Remove snap rings and spacer that retain governor body and park gear assembly on output shaft (Fig. 109).





12. Remove bolts holding governor body to park gear (Fig. 110).
13. Separate governor from park gear.
14. Pull park gear from rear support.