Standard Procedure - Fluid Drain and Refill
STANDARD PROCEDURE - FLUID DRAIN AND REFILLThe fill and drain plugs are both in the rear case (Fig. 91).
1. Raise vehicle.
2. Position drain pan under transfer case.
3. Remove drain and fill plugs and drain lubricant completely.
4. Install drain plug. Tighten plug to 41 - 54 Nm (30 - 40 ft. lbs.).
5. Remove drain pan.
6. Fill transfer case to bottom edge of fill plug opening with Mopar ATF +4, Automatic Transmission fluid.
7. Install and tighten fill plug to 41 - 54 Nm (30 - 40 ft. lbs.).
8. Lower vehicle.