Supplemental Restraints Verification Test

SUPPLEMENTAL RESTRAINT SYSTEM

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, SEAT BELT TENSIONER, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.


STANDARD PROCEDURE - VERIFICATION TEST
The following procedure should be performed using a DRB III scan tool to verify proper supplemental restraint system operation following the service or replacement of any supplemental restraint system component.

1. During the following test, the battery negative cable remains disconnected and isolated, as it was during the airbag component removal and installation procedures.

Fig. 5 16-Way Data Link Connector - Typical:

2. Be certain that the DRB III scan tool contains the latest version of the proper DRB III software. Connect the DRB III to the 16-way Data Link Connector (DLC). The DLC is located on the driver side lower edge of the instrument panel, outboard of the steering column.
3. Turn the ignition switch to the On position and exit the vehicle with the DRB III scan tool.
4. Check to be certain that nobody is in the vehicle, then reconnect the battery negative cable.
5. Using the DRB III, read and record the active (current) Diagnostic Trouble Code (DTC) data.
6. Next, use the DRB III to read and record any stored (historical) DTC data.
7. If any DTC is found in Step 5 or Step 6, refer to the appropriate diagnostic information.
8. Use the DRB III to erase the stored DTC data. If any problems remain, the stored DTC data will not erase. Refer to the appropriate diagnostic information to diagnose any stored DTC that will not erase. If the stored DTC information is successfully erased, go to Step 9.
9. Turn the ignition switch to the Off position for about fifteen seconds, and then back to the On position. Observe the airbag indicator in the instrument cluster. It should illuminate for six to eight seconds, and then go out. This indicates that the supplemental restraint system is functioning normally and that the repairs are complete.
If the airbag indicator fails to light, or lights and stays on, there is still an active supplemental restraint system fault or malfunction.
Refer to the appropriate diagnostic information to diagnose the problem. Symptom Related Diagnostic Procedures