Amplifier: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove glove box.
3. Remove instrument panel center bezel.
4. Remove instrument panel lower right center bezel.

Fig. 1 Amplifier Mounting:

5. Disconnect electrical harness connector from amplifier.
6. Remove mounting bolts.

INSTALLATION
1. Connect electrical harness connector and install amplifier.
2. Install mounting bolts. Tighten to 10 Nm (90 in. lbs.).
3. Install instrument panel lower right center bezel.
4. Install instrument panel center bezel.
5. Install glove box.
6. Connect battery negative cable.