Front
REMOVAL - FRONTCAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose with result. Provide a suitable support to hang the caliper securely.
1. Install prop rod on the brake pedal to keep pressure on the brake system.
2. Raise and support the vehicle.
3. Remove the tire and wheel assembly.
4. Compress the disc brake caliper.
5. Remove the banjo bolt and discard the copper washer.
6. Remove the caliper slide pin bolts.
7. Remove the disc brake caliper.
INSTALLATION - FRONT
NOTE: Install a new copper washers on the banjo bolt when installing
1. Install the disc brake caliper.
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
2. Install the banjo bolt with new copper washers to the caliper. Tighten to 27 Nm (20 ft. lbs.)
3. Install the caliper slide pin bolts tighten to 32 Nm (24 ft. lbs.)
4. Remove the prop rod.
5. Bleed the base brake system.
6. Install the tire and wheel assembly.
7. Lower the vehicle.