Cruise Control Servo Cable: Service and Repair

REMOVAL
1. Disconnect negative battery cable at battery.

Fig.6 Servo Cable At Throttle Body - 8.0L V-10 Engine:

2. Using finger pressure only, remove speed control cable connector at bellcrank by pushing connector off the bellcrank pin. DO NOT try to pull connector off perpendicular to the belicrank pin. Connector will be broken.
3. Squeeze 2 tabs on sides of speed control cable at throttle body mounting bracket (locking plate) and push out of bracket
4. Remove servo cable from servo. Refer to Speed Control Servo Removal/Installation.

INSTALLATION
1. Install end of cable to speed control servo. Refer to Speed Control Servo Removal/Installation.
2. Install cable into throttle body mounting bracket. Cable snaps into bracket.
3. Install speed control cable connector at throttle body bellcrank pin. Connector snaps onto pin.
4. Install air intake tube to top of throttle body (except 8.0L).
5. Connect negative battery cable to battery.
6. Before starting engine, operate accelerator pedal to check for any binding.