Freewheeling Clutch

NAG1 AUTOMATIC TRANSMISSION

FREEWHEELING CLUTCH
DISASSEMBLY





1. Remove retaining ring (5) (Fig. 143) from hollow shaft (1).
2. Remove rear sun gear (4) with the K3 internally toothed disk carrier and rear freewheeling clutch F2 (3).





3. Remove snap-ring (2) (Fig. 143) for freewheel. (4) Press freewheeling clutch out of sun gear. (5) Check O-rings (6), replace if necessary. (6) Check the anti-friction bearing (Fig. 144) in the rear planetary sun gear for damage. Replace as necessary.

ASSEMBLY





1. Press freewheeling clutch F2 (Fig. 145) into sun gear (4).
2. Install snap-ring (2) for freewheeling clutch.
3. Check O-rings (6) (Fig. 145) on hollow shaft, replace if necessary.
4. Install rear sun gear (4) with K3 internally toothed disc carrier and rear freewheeling clutch (3) onto the hollow shaft.
5. Install retaining ring (5) onto hollow shaft (1).