Removal

NAG1 TRANSMISSION

Electrohydraulic Unit

REMOVAL
1. Move selector lever to position "P".
2. Raise vehicle.





3. Remove bolt (3) (Fig. 110) and screw (1) holding the heat shield (2) to the transmission.
4. Loosen guide bushing (2) (Fig. 110) and remove from transmission housing.





5. Disconnect 13-pin plug connector (1) (Fig. 111). Turn bayonet lock of guide bushing (2) anti-clockwise.





6. Drain transmission oil by unscrewing oil drain plug (8) (Fig. 112).

NOTE: If the transmission fluid is burnt or contains abraded particles, the oil cooler lines and oil cooler must be flushed out.

7. Detach oil pan (5).
8. Remove oil filter (4).
9. Unscrew Torx socket bolts (3) and remove electrohydraulic control module (2).