Keyless Entry Module: Service and Repair

SENTRY KEY REMOTE ENTRY MODULE

REMOVAL
1. Open hood, disconnect and isolate the battery negative cable.
2. Wait two minutes for the system reserve capacitor to discharge before beginning any system or component service.
3. Remove top cover - cluster.

Sentry Key Remote Entry Module (SKREEM) - Remove/Install:

4. Disconnect the one electrical connector to the SKREEM which is the transponder ring connector.
5. Pull SKREEM straight out of rear of instrument cluster and remove from vehicle.

INSTALLATION
1. Push SKREEM straight into the rear of instrument cluster.
2. Connect the one electrical connector to the SKREEM.
3. Install the top cover - cluster
4. Connect the battery negative cable.
5. Verify vehicle and system operation.
6. Close hood.

SENTRY KEY REMOTE ENTRY MODULE TRANSPONDER RING

REMOVAL
1. Open hood, disconnect and isolate the battery negative cable.
2. Wait two minutes for the system reserve capacitor to discharge before beginning any system or component service.
3. Remove the steering column shrouds.

Transponder Ring:

4. Unsnap the SKREEM transponder from the ignition cylinder.
5. Remove top cover - cluster.
6. Disconnect the transponder electrical connector from the SKREEM.
7. Maneuver wiring from instrument panel and remove transponder from vehicle.

INSTALLATION
1. Maneuver wiring through instrument panel.
2. Connect the transponder electrical connect or to the SKREEM.
3. Install the top cover - cluster
4. Snap the SKREEM transponder in place around the ignition cylinder.
5. Install the steering column shrouds.
6. Connect the battery negative cable.
7. Verify vehicle and system operation.
8. Close hood.