Vacuum Brake Booster: Service and Repair
REMOVAL1. Remove master cylinder.
2. Disconnect vacuum lines at booster.
3. Remove clip securing booster push rod to brake pedal.
4. Remove nuts from booster mounting studs.
5. Remove booster, spacer and gaskets from front cowl panel.
INSTALLATION
1. Position spacer and gaskets on booster studs.
2. Guide booster studs into cowl panel holes and seat booster on panel.
3. Install and tighten booster attaching nuts to 28 Nm (250 inch lbs.).
4. Install booster push rod on brake pedal and install clip.
5. Install booster check valve if removed and connect vacuum hose to check valve.
6. Install master cylinder.
7. Fill and bleed brake system.