LX Repair Procedure

1. Open the hood.

2. Disconnect and isolate the negative battery cable.

3. Raise the vehicle on a suitable hoist.

4. Place a suitable service jack under the transmission crossmember.

5. Remove the bolts securing the transmission crossmember to the frame and lower transmission assembly approximately 51 - 102 mm (2 - 4 in.)

6. Disconnect the input speed sensor connector, output speed sensor connector, and the transmission range sensor connector (Fig. 2).

7. Disconnect the transmission solenoid/pressure switch connector (Fig. 1).

8. Disconnect the wiring harness routing clip at the top of the transmission. Pull the wiring harness to the right side of the vehicle.

9. Proceed to the WIRING HARNESS REPAIR PROCEDURE: Step # 1

10. Reconnect the transmission solenoid/pressure switch assembly connector.

11. Connect the input speed sensor connector, output speed sensor connector, and the transmission range sensor connector.

12. Secure the wiring harness routing clip at the top of the transmission.

13. Install the four bolts securing the transmission crossmember to the vehicle. Tighten the crossmember to frame bolts to 68 N.m (50 ft.lbs.).

14. Lower the vehicle.

15. Connect the negative battery cable and reset the clock.

16. Close the hood.

17. Using the StarSCAN� perform the Quick Learn Procedure and verify the solenoid is operating properly.