Trunk / Liftgate Hinge: Service and Repair
HINGEREMOVAL
NOTE: It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
NOTE: A suitable body sealant should be used when removing or moving the hinges.
1. Support liftgate on a suitable lifting device.
2. Using a trim stick C-4755 or equivalent, remove the upper rear headliner trim.
3. Using a grease pencil or equivalent, mark the location of the hinge to aid installation.
4. Remove the liftgate bolts (2).
5. Remove the body bolts (1) and remove the hinge.
INSTALLATION
NOTE: A suitable body sealant should be used when removing or moving the hinges.
1. If necessary, paint replacement hinge before installation.
2. Install the hinge (2) and install the body bolts (1).
3. Tighten the bolts to 28 N.m (21 ft.lbs.).
4. Install the liftgate bolts (2) and tighten to 28 N.m (21 ft.lbs.).
5. Adjust liftgate if necessary.
6. Position the upper rear headliner trim and seat fully.