Module-Compass Temperature

REMOVAL
1. Disconnect and isolate the negative battery cable.




2. Remove the overhead console (4) from the head-liner.




3. Remove the screws that secure the compass mini-trip computer module (1) to the overhead console housing.
4. Disconnect the overhead console wire harness connector from the compass mini-trip computer module connector receptacle.
5. Remove the compass mini-trip computer module (1) from the overhead console housing.

INSTALLATION

NOTE: If a new compass mini-trip computer has been installed, the compass will have to be calibrated and the variance set.




1. Position the compass mini-trip computer module (1) onto the overhead console housing (2).
2. Reconnect the overhead console wire harness connector to the compass mini-trip computer module connector receptacle.
3. Install and tighten the screws that secure the compass mini-trip computer module to the overhead console housing. Tighten the screws to 2.2 Nm (20 in. lbs.).




4. Install the overhead console (4) onto the headliner.
5. Reconnect the negative battery cable.