Without Traction Control

REMOVAL





1. Raise the vehicle on a hoist.
2. Disconnect the sensor wire harness.
3. Remove the brake line mounting nut and remove the brake line from the sensor stud (2).
4. Remove the mounting stud (2) from the sensor (1) and shield.
5. Remove the sensor (1) and shield from the differential housing (3).

INSTALLATION





1. Install the O-ring on the sensor (1) (if removed).
2. Insert the sensor (1) in the differential housing (3).
3. Install the sensor shield.
4. Install the sensor mounting stud (2) and tighten to 24 Nm (200 in. lbs.).
5. Install the brake line on the sensor stud (2) and install the nut.
6. Connect the harness to the sensor. Be sure the seal is securely in place between the sensor and the wiring connector.
7. Lower the vehicle.