Manifold Pressure/Vacuum Sensor: Service and Repair

REMOVAL




The Manifold Absolute Pressure (MAP) sensor (2) is mounted into the front of the intake manifold.

1. Disconnect electrical connector at sensor.
2. Clean area around MAP sensor.
3. Remove two sensor mounting screws (1).
4. Remove MAP sensor from intake manifold.




5. Check condition of sensor O-ring (2).

INSTALLATION
The Manifold Absolute Pressure (MAP) sensor is mounted into the front of the intake manifold. An O-ring is used to seal the sensor to the intake manifold.

1. Clean MAP sensor mounting hole at intake manifold.
2. Check MAP sensor O-ring seal for cuts or tears.
3. Position sensor into manifold.
4. Install MAP sensor mounting bolts (screws) torque to 3 N.m (25 in. lbs.).
5. Connect electrical connector.