Trunk / Liftgate: Service and Repair

LIFTGATE

REMOVAL

WARNING: Do not disconnect the support rod cylinders with the liftgate closed. The support rod pistons are operated by high pressure gas. This pressure could cause damage and/or personal injury if they are removed while the pistons are compressed.




1. Open and support the liftgate.
2. Disconnect the power liftgate link rod, if equipped.
3. Using a trim stick C-4755 or equivalent, remove the upper rear headliner trim.
4. Remove the support cylinders from the liftgate.
5. Disconnect the wire harnesses and the washer hose.
6. Using a grease pencil or equivalent, mark the hinge location.
7. Remove the six liftgate to body bolts (1) and remove liftgate from vehicle.

INSTALLATION

NOTE: A suitable body sealant should be used when removing or moving the hinges.




1. Position the liftgate onto the vehicle and install the six body bolts (1).
2. Tighten the bolts to 28 N.m (21 ft.lbs.).
3. Check and adjust the liftgate if necessary.
4. Connect the power liftgate link rod, if equipped.
5. Position the upper rear headliner trim and seat fully.