Rear Door Window Glass: Service and Repair

GLASS

REMOVAL




1. Remove the watershield. Refer to Rear Door Panel.
2. Separate the inner belt molding from the mounting flange from the rear to the front.
3. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.
4. Push down on outer belt molding (1) and rotate upper part of tool (2) outward from vehicle then lift up on molding (1) to disengage from locking tabs (3) working from back to front.

NOTE: Typical outer belt molding design shown.

5. Slide molding out from under the side view mirror and remove.




6. Temporarily install the window switch and position the glass (1) to gain access (2) to the regulator nuts (4).
7. Remove the nuts (4) and remove the glass (1).

NOTE: When removing the quarter glass, remove rear glass run channel and weather strip and separate the glass from the strip. Refer to Window Track.

INSTALLATION

NOTE: When installing the quarter glass, position the glass in the glass run weather strip and seat fully then install the rear glass run channel. Refer to Window Track.




1. Position the glass into the door and install onto the regulator.
2. Install the nuts (4) and tighten to 9 N.m (80 in.lbs.).
3. Position the outer belt molding onto the door and seat the molding fully starting at the back of the door.
4. Position the inner belt molding onto the door and seat fully starting at the back of the door.
5. Install the watershield.