Memory Seat Module Replacement

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the driver seat cushion/cover (2).
3. Unsnap the memory seat module (4) from the side brackets.
4. Pivot the module upward and disconnect the electrical connectors (1).
5. Pull the module rearward to remove it from the front of the seat frame (3).

INSTALLATION




1. Place the module (4) into position making sure the front snaps into the seat frame (3).
2. Connect the memory seat module harness connectors (1).
3. Pivot the module (4) downward and snap it into place in the side brackets.
4. Install the driver seat cushion/cover (2)
5. Connect the battery negative cable.
6. Verify system and vehicle operation.