Defroster Grille Replacement

REMOVAL




1. Before proceeding with the following repair procedure, review all warnings and cautions.
2. Using a trim stick C-4755 or equivalent, remove the drivers side a-pillar trim.
3. Open the trim covers in the passenger side a-pillar grab handle and remove the bolts.
4. Remove the right a-pillar trim panel.
5. Using a trim stick C-4755 or equivalent, remove the instrument panel defroster grille.
6. Disconnect the sensor electrical connector (2).
7. Remove the screw (4) and remove the sun sensor (1).

INSTALLATION




1. Before proceeding with the following repair procedure, review all warnings and cautions.
2. Install the sun sensor (1) and install the screw (4).
3. Position the defroster grille (2) into place and connect the electrical connector (3).
4. Position the drivers side a-pillar trim into place and seat the retaining clips fully.
5. Position the passenger side a-pillar trim panel into place and seat fully.
6. Install the bolts and tighten to 6 Nm (55 in. lbs.).