Keyless Entry Module: Service and Repair

SENTRY KEY REMOTE ENTRY MODULE

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the Steering Column Opening Cover (Refer to BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - REMOVAL).
3. Remove the steering column upper and lower shrouds (Refer to STEERING/COLUMN/UPPER SHROUD - REMOVAL) and (Refer to STEERING/COLUMN/LOWER SHROUD - REMOVAL).
4. Disengage the steering column wire harness from the Sentry Key Remote Entry Module (SKREEM).
5. Remove the one screws securing the SKREEM to the steering column.
6. Rotate the SKREEM upwards and then to the side away from the steering column to slide the SKREEM antenna ring from around the ignition switch lock cylinder housing.
7. Remove the SKREEM from the vehicle.

INSTALLATION
1. Slip the Sentry Key Remote Entry Module (SKREEM) antenna ring around the ignition switch lock cylinder housing. Rotate the SKREEM downwards and then towards the steering column.
2. Install the one screws securing the SKREEM to the steering column.
3. Connect the steering column wire harness to the SKREEM.
4. Install the steering column upper and lower shrouds (Refer to STEERING/COLUMN/UPPER SHROUD - INSTALLATION) and (Refer to STEERING/COLUMN/LOWER SHROUD - INSTALLATION).
5. Install the Steering Column Opening Cover (Refer to BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION)
6. Connect the battery negative cable.