Driver Seat Switch Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the seat cushion side shield from the seat. Refer to the Body section for the procedure.
3. Pull the switch bezel or side shield unit out from the seat far enough to access the switch wire harness connector. Gently pry the locking tabs of the switch away from the wire harness connector and carefully unplug the connector from the power seat switch module.

Power Seat Switch Remove/Install - Typical:

4. Remove the screws that secure the power seat switch.

INSTALLATION
1. Position the power seat switch on the seat cushion side shield and install the screws that secure the power seat switch to seat cushion side shield.
2. Connect the electrical connector.
3. Install the seat cushion side shield on the seat. Refer to the Body section of the service manual for the procedure.
4. If equipped, install the screw that secures the recliner lever to the recliner mechanism release shaft on the outboard side of the front seat.
5. Connect the battery negative cable.