Trip Computer: Service and Repair

COMPASS MINI-TRIP COMPUTER

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove overhead console. Refer to Overhead Console Removal and Installation in this section (Refer to OVERHEAD CONSOLE - REMOVAL).
3. Remove the screws holding Compass Mini-Trip Computer module in the overhead console.
4. Remove CMTC module from console assembly

INSTALLATION
1. Position the compass mini-trip computer module in the overhead console.
2. Install the screws holding the compass mini-trip computer module in the overhead console.
3. Install the overhead console (Refer to OVERHEAD CONSOLE - INSTALLATION).
4. Connect the battery negative cable.

NOTE: If a new module has been installed, the compass will have to be calibrated and the variance set. Refer to Compass Variation Adjustment and Compass Calibration in the Service Procedures section of this group for the procedures.