Front Seat
SEAT-FRONTREMOVAL
1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.
NOTE: Do not reuse the seat fasteners, always replace with new ones.
2. Remove and discard the front bolts (4).
3. Position the seats (1) forward, remove the rear bolts (2) and discard.
4. Disconnect the electrical connectors (1).
5. Fold the seat backs forward and roll the seat assembly back in the vehicle.
6. Remove and discard the nuts (2 and 4) on either the driver or passenger side.
7. Separate the seat assembly by removing and discarding the nuts (4) on either the drivers or passengers seat.
8. Remove each section of the seat assembly from the vehicle.
INSTALLATION
1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions
NOTE: Do not reuse the seat fasteners, always replace with new ones.
2. Position each seat section into the vehicle and tip back.
3. Install the nuts (4) attaching the center seat section (2) to the other seat, and tighten to 25 N.m (18 ft.lbs.).
4. Install the nuts (2 and 4) attaching the center seat section to the other seat, and tighten to 25 N.m (18 ft.lbs.).
5. Connect the electrical connectors (1).
6. Roll the seat assembly forward and install new rear bolts (2). Tighten the bolts (2) to 40 N.m (30 ft.lbs.).
7. Fold the seat backs up and slide the seats (1) to the rear.
8. Install new front bolts (4) and tighten to 28 N.m (21 ft.lbs.).