Fog/Driving Lamp: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Reach under and behind the front bumper to access and disconnect the headlamp and dash wire harness connector (3) from the front fog lamp socket connector.
3. Remove the three screws (1) that secure the front fog lamp housing (2) to the front bumper support.
4. Remove the front fog lamp from behind the front bumper.

INSTALLATION




1. Reach under and behind the front bumper to position the front fog lamp (2) to the front bumper support.
2. Install and tighten the three screws (1) that secure the front fog lamp housing to the bumper support. Tighten the screws to 5 N.m (40 in.lbs.).
3. Reconnect the headlamp and dash wire harness connector (3) to the front fog lamp socket connector.
4. Reconnect the battery negative cable.
5. Confirm proper front fog lamp alignment.