Air Temperature Sensor ( Ambient / Intake ): Service and Repair

REMOVAL

NOTE: Take care not to damage the thermistor pill when removing the sensor.




1. Remove the battery cover and disconnect the negative battery cable.
2. Disconnect the electrical connector from the inlet temperature sensor.
3. Remove sensor from inlet hose.

INSTALLATION

NOTE: Take care not to damage the open thermistor pill when installing the sensor.




1. Install sensor , use a little water to aid in insertion of sensor.
2. Make sure that the rib on the sensor matches up with the rib on the inlet hose. The thermistor pill should be in direct contact with the inlet air stream.
3. Connect the electrical connector.
4. Connect the negative battery cable and install battery cover.