Back Window Regulator: Service and Repair

BACKLITE VENT GLASS-REGULATOR

REMOVAL

1. Disconnect and isolate the battery negative cable.
2. Remove the rear seats.
3. Remove the rear cab back panel, Refer to Trim Panel.




4. Remove the two mounting bolts (1).
5. Disconnect the electrical connector to the power motor.




6. Separate the cable housings from the glass track (1).
7. Disconnect the cable ends from the vent glass (2).
8. Separate the support clips (5) and remove the regulator assembly (3).

INSTALLATION




1. Connect the cable ends to the vent glass (2).
2. Install the cable housings into the glass tracks (1).
3. Fasten the support clips (5).




4. Install the 2 mounting bolts (1).
5. Install the rear cab back panel.
6. Install the rear seats.
7. Connect the battery negative cable.