Underhood Lamp: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Disconnect the headlamp and dash jumper harness connector (2) from the underhood lamp (3) connector receptacle.
3. Remove the screw (4) that secures the underhood lamp mounting bracket to the inner hood panel (1).
4. Remove the underhood lamp and bracket from the inner hood panel as a unit.

INSTALLATION




1. Position the underhood lamp and bracket (3) to the underside of the hood panel (1) as a unit. Be certain that the locating tab (5) on the bracket is engaged into the locating hole in the hood inner panel.
2. Install the tighten the screw (4) that secures the underhood lamp mounting bracket to the inner hood panel. Tighten the screw to 5 N.m (45 in.lbs.).
3. Reconnect the headlamp and dash jumper harness connector (2) to the underhood lamp connector receptacle.
4. Reconnect the battery negative cable.