Integrated Power Module (IPM)

REMOVAL
1. Disconnect and isolate the battery negative cable.





2. Remove cove (4) by loosening the cover screw (1).
3. Remove the B+ terminal nut from the Integrated Power Module (IPM) B+ terminal. Remove the B+ cable from the IPM.
4. Disconnect the gray connector from the IPM.





5. Remove the IPM retaining bolt (2) and screw (3).
6. Grasp the IPM with two hands and slide the assembly in the direction shown to free the module from its mounting bracket. Position the assembly upside down to access the electrical connectors located on the bottom of the unit.
7. Disconnect the electrical connectors by depressing the locking tab and rotating the connector arm out-board, until the connector is free from the IPM assembly. Be certain to pull the connectors straight off.
8. Remove the IPM from the vehicle.

INSTALLATION




1. Position the Integrated Power Module (IPM) into the vehicle.

NOTE: Integrated power module electrical connectors are color coded to ease location reference.

2. Connect the electrical connectors by pushing straight on and rotating the connector arm inboard, until the connector is firmly locked in place on the IPM assembly.




3. Grasp the IPM (3) with two hands and install the assembly onto the battery tray (2) making sure to line up the tabs with the retaining slots in the tray (1).




4. Install the IPM retaining bolt (2) and screw (3).
5. Connect the gray connector on the IPM housing.
6. Install the B+ terminal cable and nut on the B+ terminal.
7. Install the IPM cover (4) and tighten the retaining screw (1).
8. Connect the battery negative cable.