Turbo Boost Sensor: Service and Repair

REMOVAL





The combination, dual function Intake Manifold Air Temperature Sensor/MAP (IAT/MAP) sensor is installed (2) into the top of the intake manifold.

1. Clean area around sensor.
2. Disconnect electrical connector (3) from IAT/MAP sensor.
3. Remove two T-15 Torx headed screws (4).
4. Remove sensor from intake manifold.




5. Check condition of sensor O-ring (2).

INSTALLATION
1. Check condition of sensor O-ring.
2. Lubricate sensor O-ring with clean engine oil.
3. Clean sensor mounting area at intake manifold.
4. Position sensor into intake manifold.
5. Install and tighten 2 sensor mounting screws to 1 Nm (9 in. lbs.) torque.
6. Connect electrical connector to sensor.