Pedal Positioning System: Service and Repair
PEDALREMOVAL
NOTE: The brake pedal is serviced as a complete assembly including accelerator pedal and the bracket.
1. Disconnect the negative battery cable.
2. Remove the steering column opening cover.
3. Remove the brake lamp switch and discard.
4. On vehicles equipped with adjustable pedals. Disconnect the adjuster cable (1) to the pedal (2).
5. Remove the steering column.
6. Remove the brake booster (5).
7. Disconnect the electrical connectors.
8. Remove the module mounting bolts.
9. Disconnect the accelerator pedal cable.
10. Remove the pedal assembly mounting nuts/fasteners (4).
INSTALLATION
1. Install the pedal assembly (4) to the vehicle.
2. Install the mounting bolts (3) and tighten to 28 Nm (21 ft. lbs.).
3. Reconnect the accelerator cable (1) to the pedal (2).
4. Install the module mounting bolts and tighten to 38 Nm (28 ft. lbs.).
5. Reconnect the electrical connectors.
6. Install the brake booster.
7. Install the steering column.
8. Install a new brake lamp switch.
9. On vehicles equipped with adjustable brake pedal. Reconnect the electrical connector to the motor and the adjuster cable at the pedal.
10. Install the steering column opening cover.
11. Reconnect the negative battery cable.