Overdrive Assembly: Service and Repair
SOLENOID / PRESSURE SWITCH ASSYREMOVAL
NOTE: If solenoid/pressure switch assembly is being replaced, the "Quick-Learn" procedure must be performed.
1) Disconnect battery negative cable.
2) Remove air cleaner assembly.
Fig. 295 Transmission Connectors:
3) Disconnect solenoid/pressure switch assembly connector (1) (Fig. 295).
4) Disconnect input speed sensor connector (2).
Fig. 296 Input Speed Sensor:
5) Remove input speed sensor (1) (Fig. 296).
Fig. 297 Solenoid/Pressure Switch Assembly-to-Case Bolts:
6) Remove three solenoid/pressure switch assembly-to-transaxle case bolts (1) (Fig. 297).
Fig. 298 Solenoid/Pressure Switch Assembly andGasket:
7) Remove solenoid/pressure switch assembly (1) (Fig. 298) and gasket (2). Use care to prevent gasket material and foreign objects from become lodged in the transaxle case ports.
INSTALLATION
NOTE: If solenoid/pressure switch assembly is being replaced, it is necessary to perform the "Quick-Learn" procedure.
Fig. 299 Solenoid/Pressure Switch Assembly andGasket:
1) Install solenoid/pressure switch assembly and new gasket to transaxle (Fig. 299).
Fig. 300 Solenoid/Pressure Switch Assembly-to-Case Bolts:
2) Install and torque three bolts (1) (Fig. 300) to 12 Nm (0.05 inch lbs.).
Fig. 301 Input Speed Sensor:
3) Install input speed sensor (1) (Fig. 301) and torque to 27 Nm (20 ft. lbs.).
Fig. 302 Transmission Connectors:
4) Connect input speed sensor connector (2) (Fig. 302).
5) Install solenoid/pressure switch 8-way connector and torque to 4 Nm (35 inch lbs.).
6) Install air cleaner assembly.
7) Connect battery negative cable.
8) If solenoid/pressure switch assembly was replaced, perform the "Quick-Learn" procedure.