Speed Sensor - Input

SPEED SENSOR - INPUT

REMOVAL

Fig. 306 Transmission Connectors:

1) Disconnect battery negative cable. (2) Disconnect input speed sensor connector (2) (Fig. 306).

Fig. 307 Input (Turbine) Speed Sensor:

3) Unscrew and remove input speed sensor (1) (Fig. 307).

Fig. 308 O-ring Location:

4) Inspect speed sensor O-ring (2) (Fig. 308) and replace if necessary.

INSTALLATION

Fig. 309 O-ring Location:

1) Verify O-ring (2) (Fig. 309) is installed into position.

Fig. 310 Input (Turbine) Speed Sensor:

2) Install and tighten input speed sensor (1) (Fig. 310) to 27 Nm (20 ft. lbs.).

Fig. 311 Transmission Connectors:

3) Connect speed sensor connector (2) (Fig. 311).
4) Connect battery negative cable.