Radio/Stereo: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove cup holder.
3. Remove trim panel above cupholder by pulling straight out.
4. Remove center instrument panel trim panel.
5. Remove screws holding radio to instrument panel.

Radio:

6. Pull radio rearward to gain access to the back of radio.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

Antenna To Radio:

7. Disconnect the antenna cable by pulling the locking antenna connector away from the radio.
8. Disconnect the wire connectors from the back of the radio.

INSTALLATION
1. Connect wire harness to back of radio.
2. Connect antenna cable to back of radio.
3. Position radio into instrument panel.
4. Install screws holding radio to instrument panel.
5. Install center instrument panel trim.
6. Install trim panel above cupholder.
7. Install cupholder.
8. Connect battery negative cable.