Alternator: Service and Repair

REMOVAL
1. Release hood latch and open hood.
2. Disconnect battery negative cable.
3. Disconnect the push-in field wire connector from back of generator.
4. Remove nut holding B+ wire terminal to back of generator.
5. Separate B+ terminal from generator.
6. Raise vehicle and support.
7. Remove the right front lower splash shield.
8. Remove accessory drive belt.

Dip Stick Lower Bolt:

9. Remove the lower oil dip stick tube bolt.
10. Remove wiring harness from the oil dip stick tube
11. Remove the 3 mounting bolts.
12. Lower vehicle.
13. Remove oil dip stick tube from vehicle.

Generator 3.3L/3.8L:

14. Roll and remove the generator from vehicle.

INSTALLATION
1. Roll and place generator in position on vehicle.
2. Install upper bolts to hold generator in place.
3. Lubricate the O-ring. Install oil dip stick tube.
4. Install the upper oil dip stick tube bolt.
5. Place B+ terminal in position on generator.
6. Install nut to hold B+ wire terminal to back of generator.
7. Connect the push-in field wire connector into back of generator.
8. Raise vehicle and support.
9. Install the lower mounting bolt and tighten.
10. Install the lower oil dip stick tube bolt and tighten.
11. Install accessory drive belt.
12. Install the right front lower splash shield.
13. Lower vehicle.
14. Install wiring harness to the oil dip stick tube
15. Connect battery negative cable.
16. Verify generator output rate.