Power Seat Switch: Service and Repair
SWITCH-SEAT-DRIVERREMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the screw (4) that secures the recliner lever (5) to the recliner mechanism release shaft on the outboard side of the driver side front seat cushion side shield (2).
3. Pull the recliner lever (5) off of the recliner mechanism release shaft.
4. Remove the two screws (3) and (6) that secure the driver side seat cushion side shield (2) to the outboard seat cushion frame.
5. Pull the driver side seat cushion side shield (2) away from the seat cushion frame far enough to access the power seat switch assembly (1) wire harness connector.
6. Unplug the wire harness connector from the power seat switch module.
7. Remove the seat cushion side shield and power seat switch module from the seat as a unit.
8. Remove the two screws (3) that secure the power seat switch (2) to the inside of the seat cushion side shield (1).
9. Remove the power seat switch from the seat cushion side shield.
INSTALLATION
1. Install the two screws (3) that secure the power seat switch (2) to the inside of the seat cushion side shield (1).
2. Install the wire harness connector on the power seat switch assembly.
3. position the seat cushion side shield (2) and power seat switch assembly (1) onto the seat frame.
4. Install the seat cushion side shield screws (3) and (6).
5. Install the recliner lever (5) on the recliner mechanism release shaft.
6. Install the screw (4) that secures the recliner lever (5) to the recliner mechanism release shaft on the outboard side of the driver side front seat
7. Connect the battery negative cable.