Fog/Driving Lamp: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the front fascia from the front bumper support.
3. Reach under and behind the front of the vehicle to access the front fog lamp housing (3) on the back of the front bumper support (5).
4. Disconnect the wire harness connector (1) from the fog lamp bulb socket.
5. Remove the two screws (2) that secure the fog lamp mounting bracket to the bumper support.
6. Release the three integral latch clips (4) that secure the fog lamp mounting bracket to the opening in the bumper support.
7. Remove the lamp and mounting bracket as a unit from the seat in the face of the bumper support.

INSTALLATION




1. Position the front fog lamp (3) and mounting bracket as a unit into the seat on the face of the front bumper support (5).
2. Be certain that the alignment pins (6) on the back of the lamp mounting bracket are inserted through the alignment holes in the back of the seat, then press on the front of the lamp using hand pressure until the three latch clips (4) on the mounting bracket are fully engaged in the opening in the bumper support.
3. From the back of the bumper support, install and tighten the two screws (2) that secure the lamp mounting bracket to the bumper support. Tighten the screws to 2 N.m (14 in. lbs.).
4. Reconnect the wire harness connector (1) to the fog lamp bulb socket.
5. Reinstall the front fascia onto the bumper support.
6. Reconnect the battery negative cable.
7. Confirm proper front fog lamp alignment.