B1D0D
B1D0D,B1D16 - MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH - MEMORY MIRROR MODULEB1D0D, B1D16 - Mirror Vertical Position Sensor Input Circuit High - Memory Mirror Module:
WHEN MONITORED
Continuously.
SET CONDITION
When the Memory Mirror Module senses a value above the parameter of the mirror sensor on the Mirror Vertical Position Signal circuit for over 60 ms, this code will set.
NOTE: This test covers both the Driver and Passenger code depending on the side the code appeared in.
POSSIBLE CAUSES
- (P67) or (P64) mirror vertical position signal circuit short to voltage
- (P69) or (P66) mirror sensor ground circuit open
- Mirror shorted
- Driver memory mirror module
Diagnostic Test
1. TEST FOR INTERMITTENT CONDITION
Turn the ignition on.
With the scan tool, record and erase DTC's
Operate the Mirror Switch in all directions several times.
Cycle the ignition from on to off three times.
Turn the ignition on.
With the scan tool, read DTC's.
Q: Does the scan tool display B1D0C or B1D15-MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH?
YES: Go To 2
NO: The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
2. TEST FOR A SHORTED MIRROR
Disconnect the appropriate mirror connector.
With the scan tool, erase DTC's.
Operate the Mirror Switch in all directions several times. Cycle the ignition from on to off 3 times.
Turn the ignition on.
With the scan tool, read DTC's.
Q: Does the scan tool display B1D0C or B1D15-MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH?
NO: Replace the Mirror. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
YES: Go to 3
3. TEST THE (P67) OR (P64) MIRROR VERTICAL POSITION SIGNAL WIRE FOR A SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the appropriate Memory Mirror Module connector.
Measure the voltage between the (P67) or (P64) Mirror Vertical Position Signal circuit and ground.
Q: Is there any voltage present?
YES: Repair the (P67) or (P64) Mirror Vertical Position Signal circuit for a short to voltage. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Go to 4
4. TEST THE (P69) OR (P66) MIRROR SENSOR GROUND WIRE FOR AN OPEN
Measure the resistance of the (P69) or (P66) Mirror Sensor Ground circuit between the Module connector and the Mirror connector.
Q: Is the resistance below 2.0 ohms?
NO: Repair the (P69) or (P66) Mirror Sensor Ground circuit for an open. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
YES: Replace the appropriate Memory Mirror Module. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test