C2202

C2202 - ORIGINAL VIN MISMATCH/MISSING

For a complete wiring diagram Refer to the Wiring Information.

- When Monitored:
At power up, VIN is read off the CAN bus.

- Set Condition:
The VIN stored in the ABM does not match the VIN read off of the CAN bus.






1. CHECK FOR A DTC C2202-ORIGINAL VIN MISMATCH/MISSING

NOTE: This DTC must be active for the results of this test to be valid.

1. Turn the ignition on.
2. With the scan tool, read and record DTCs.
3. With the scan tool, read and record Freeze Frame information.
4. Perform ECU initialization with drive test. Refer to ABS VERIFICATION TEST - VER 1.
5. Start the engine.
6. With the scan tool, read and record DTCs.

Does the scan tool display: C2202-ORIGINAL VIN MISMATCH/MISSING?

Yes
- Go To 2

No
- Refer to the INTERMITTENT CONDITION diagnostic procedure.
- Perform ABS VERIFICATION TEST - VER 1.

2. WRONG VIN PROGRAMMED INTO VEHICLE

Is the correct VIN programmed into the vehicle?

Yes
- Replace the Anti-Lock Brake Module in accordance with the Service Information.
- Perform ABS VERIFICATION TEST - VER 1.

No
- Reprogram the VIN per service information.
- Perform ABS VERIFICATION TEST - VER 1.