P0613

P0613-INTERNAL TRANSMISSION PROCESSOR

- When Monitored:
After the ignition key is turned to the run position and 60 seconds thereafter.
- Set Condition:
Either of the following conditions occur 3 times in less than 590 milliseconds: The watchdog line remains high after the watchdog test or the transmission relay coil is energized and remains on after the watchdog delay expires.

Possible Causes
- PCM - INTERNAL ERROR

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Testing and Inspection

Theory of Operation
The internal watchdog is a separate hardware circuit which continuously monitors the microprocessor. To make sure the transmission is operating properly, the watchdog must receive a signal from the microprocessor within a specific time window. MIL on after 10 seconds of vehicle operation and transmission will be placed in limp-in.

Diagnostic Test
1. PCM - INTERNAL ERROR
Using the schematics as a guide, inspect the wiring and connectors. Repair as necessary Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
Repair
Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for Service Information Tune-ups or Service Bulletins for any possible causes that may apply If no problems are found, replace the PCM. With the scan tool, perform QUICK LEARN. Perform 42RLE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests