P0700

P0700-TRANSMISSION CONTROL SYSTEM (MIL REQUEST)


WHEN MONITORED:
Ignition on and battery voltage greater than 10 volts.

SET CONDITION:
An active DTC is stored in the TCM. One Trip Fault. Three good trips to turn off the MIL.

POSSIBLE CAUSES
- DTC present in the transmission control module

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Diagnostic Test

1. DTC PRESENT IN EATX CONTROLLER

This is an informational DTC letting you know that a DTC(s) is stored in the Transmission Control Module.
Erase this DTC from the PCM after all Transmission DTC(s) have been repaired.
Using a scan tool, read the Transmission Controller DTC and refer to the Transmission Category and perform the appropriate symptom.

PCM Diagnostic Information complete.

Continue
Test Complete.