Power Trunk / Liftgate Control Module: Service and Repair

POWER LIFTGATE CONTROL MODULE

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the left quarter trim panel from the vehicle.
3. Disconnect the wire harness connectors (2) from the power liftgate control module (4).
4. Using molding remover C-4829-A gently pry the clip (1) out of the retaining hole holding the power liftgate control module (4) to the quarter panel.
5. Tilt the top of the module (4) away from the quarter panel and lift upward to disengage the mounting tab from the locating slot (3).
6. Remove the power liftgate control module (4) from the vehicle.

INSTALLATION




1. Position the power liftgate control module (4) into the vehicle.
2. Insert the mounting tab into the locating slot (3) on the quarter panel.
3. Tilt the top of the module (4) toward the quarter panel and firmly press the clip (1) into the retaining hole on the quarter panel.
4. Connect the wire harness connectors (2) to the power liftgate control module (4).
5. Install the left quarter trim panel.
6. Connect the battery negative cable.
7. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
8. Perform the power liftgate learn cycle.
9. Verify power liftgate system operation.