Front Seat Cushion

CUSHION/COVER-CUSHION - FRONT

REMOVAL




1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.
2. Move the seat to the forward position and disconnect and isolate the batter negative cable.
3. Remove the bolts (2) and the clamps (1) and remove the seat cushion.
4. Disconnect the electrical connector, if equipped.




5. Separate the J-straps (1 & 2) and seat cushion cover and foam.

INSTALLATION




1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.
2. Position the cushion cover and foam over the seat pan and connect the J-straps (1 & 2).




3. Position the seat cushion assembly onto the seat frame and install the clamps (1).
4. Connect the wire harness to the seat cushion pan, if equipped.
5. Install the bolts (2) and tighten to 10 N.m (90 in.lbs.).
6. Connect battery negative cable.