Lamp

WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, OCCUPANT CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. The center bezel lamp unit (1) is located on the instrument panel center support structure, which forms the roof of the center floor console forward storage bin. Reach into the storage compartment and use a small thin-bladed screwdriver to depress the lamp retaining latch (4) on the end of the lamp housing nearest the lens (3).
3. Pull the lamp down and rearward to disengage the fixed retainer (2) from the mounting hole.
4. Disconnect the wire harness connector from the lamp connector.
5. Remove the lamp unit from the storage bin.

INSTALLATION




1. Position the center bezel lamp unit (1) into the forward storage bin of the center floor console.
2. Reconnect the wire harness connector to the lamp connector.
3. Engage the fixed retainer (2) of the lamp with the forward edge of the mounting hole in the instrument panel support structure.
4. Push the rearward end of the lamp upward until the retaining latch (4) snaps into the mounting hole.
5. Reconnect the battery negative cable.