Trunk Lamp: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Insert a trim stick or another suitable wide flat-bladed tool, between the liftgate lamp housing (3) and the lamp seat in the liftgate trim panel (1).
3. Carefully pry the liftgate lamp unit outward from the trim panel.
4. Disconnect the wire harness connector (2) from the back of the lamp housing.
5. Remove the lamp from the liftgate.

INSTALLATION




1. Position the liftgate lamp unit (3) to the lamp seat in the liftgate trim panel (1).
2. Reconnect the wire harness connector (2) to the back of the lamp housing.
3. Align the latch tabs on the back of the lamp housing with the receptacles in the trim panel.
4. Using hand pressure, press firmly and evenly on the lamp lens until the lamp snaps into the trim panel.
5. Reconnect the battery negative cable.