Trunk Light Bulb: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the liftgate lamp unit from the liftgate trim panel. .
3. Using a small thin-bladed screwdriver, gently pry between the lamp lens (2) and the lamp housing (1) at the two upper or lower snap features to remove the lens from the housing.
4. Disengage the ends of the bulb (3) from the two bulb holders within the lamp housing.

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.




1. Install the ends of the bulb (3) onto the two bulb holders within the liftgate lamp housing (1).
2. Align the lamp lens (2) with the lamp housing, then use firm and even hand pressure to snap the lens onto the housing.
3. Reinstall the lamp onto the liftgate trim panel.
4. Reconnect the battery negative cable.